HP Officejet 7210 - Select your fax setup case

Select your fax setup case

Now that you have answered all of the questions about the equipment and services
that share the phone line with your HP All-in-One, you are ready to choose the best
setup case for your home or office.
From the first column in the following table, choose the combination of equipment and
services applicable to your home or office setting. Then look up the appropriate setup
case in the second or third column based on your phone system. Step-by-step
instructions are included for each case later in this chapter.
If you have answered all of the questions in the previous section and have none of the
described equipment or services, choose "None" from the first column in the table.

Note

If your home or office setup is not described in this chapter, set up the

HP All-in-One as you would a regular analog phone. Make sure you use the
phone cord supplied in the box to connect one end to your telephone wall jack
and the other end to the port labeled "1-LINE" on the back of your HP All-in-
One. If you use another phone cord, you might experience problems sending
and receiving faxes.

Other equipment/services
sharing your fax line

Recommended fax setup
for parallel-type phone
systems

Recommended fax setup
for serial-type phone
systems

None
(You answered No to all
questions.)

Case A: Separate fax line (no
voice calls received)

Case A: Separate fax line
(no voice calls received)

DSL service
(You answered Yes to question
1 only.)

Case B: Set up your HP All-
in-One with DSL

Case B: Set up your HP All-
in-One with DSL

PBX or ISDN system
You answered Yes to question
2 only.)

Case C: Set up your HP All-
in-One with a PBX phone
system or an ISDN line

Case C: Set up your HP All-
in-One with a PBX phone
system or an ISDN line

Chapter 10

78

HP Officejet 7200 All-in-One series

Fax setup